1) Make sure all tires are inflated to the vehicle's recommended inflation pressures (found in the owner's manual on the door placard)
2) Make sure the ignition button is OFF then press and release the brake pedal
3) Hold the ignition button down for 2 seconds, release it, and then tap the button once. The vehicle should be OFF. Hold the ignition button down for another two seconds, release it, and then tap the button once
4) Hold the ignition button down for two seconds again. The vehicle should be in RUN mode, engine off
5) Press and release the brake pedal
6) Tap the ignition button once so the vehicle is OFF
7) Hold the ignition button down for 2 seconds, release it, and then tap the button once. The vehicle should be OFF. Hold the ignition button down for another two seconds, release it, and then tap the button once
8) Hold the ignition button down for two seconds again. The vehicle should be in RUN mode, engine off
9) The horn should sound letting you know the vehicle has entered into TPMS relearn mode
10) Starting with the driver;s side front tire, activate the TPM sensor by deflating the tire for 10 seconds. Wait for the horn honk to confirm that the sensor has been registered to the vehicle. It may take up to 20 seconds for the horn to honk
11) Once the horn sounds, move on to the passenger side front tire and repeat the process. Each tire should only take 30 seconds or less.
12) After the passenger side front tire has been learned, continue on to the passenger side rear tire and finishing with the driver's side rear tire
13) You may now turn the ignition to OFF. If the horn does not sound, the sensors were learned successfully. If the horn sounds twice, then the process must be repeated because there was a malfunction
14) Make sure all tires, including the spare (if equipped) are inflated to the vehicle's recommended inflation pressures